Fibreglass Planter

The upper edge of these planters is reversed twice, which gives these planters a splendid timeless appearance. The planters are manufactured with high-quality reinforced Fibreglass. Because the reinforcement has been extended into the corners, these corners cannot tear out. The planter is coloured through the entire material and will therefore retain its colour.

Dimensions: 1500x500x600

Available in 3 colours.

Once constructed the planters get the following treatments:
1. Roughing of the material for a proper bonding
2. Powder coated with a strong adhesive primer
3. Finished with a scratch resistant coloured coating

Advantages:

• Manufactured with high-quality reinforced Fibreglass
• Lightweight and very strong
• Coloured throughout the entire material

Planting advise:
• Place the overflow pipes in the drainage holes prepared for this purpose
• Fill the container with about 10 cm of drainage material
• A water-permeable anti-root fabric on top of the drainage material
• Use soil that is suitable for the type of planting
• Keep drainage holes clear so that the excess water can drain away

Important:
• The products must be unpacked immediately after delivery so any moisture between the packaging and the product is not sealed. This can cause stains that are difficult to remove.
• Fibreglass planters must always be placed directly on a flat surface. Do not place the planters on stones and beams etc.

Note! Always drill drainage holes in the bottom of the planter, use (if present) the raised parts of the bottom of the planter.

• Closed circles (connected to a water gutter) are provided in the bottom for the required drainage. In these circles you can drill ± 2,5 cm diameter holes and place an overflow pipe.

Overflow pipe is included in the price.